Difference between revisions of "Template:Getting Started"
From Tinkla: Tinkering with Tesla
|
|
| (21 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| − | <big><big>Work in Progress</big></big><br />
| |
| − | This page is the first pass at replacing the Main Page "Getting Started" section.
| |
| | | | |
| − | __toc__
| |
| − |
| |
| − | <big><big>Quick Start</big></big><br />
| |
| − | If you are looking to get your EON up and running see the following guides
| |
| − |
| |
| − | == Installing a Giraffe ==
| |
| − | There are currently three options concerning Giraffes for your Model S.
| |
| − | # Giraffe revC from @AsianTea#7596 on the [https://discordapp.com/invite/Wyna3qy Comma.ai discord]
| |
| − | #* This solution doesn't need any modification to perform a Radar retrofit.
| |
| − | # An EPAS harness from [https://www.ebay.com/str/level2tesla Flyboy222pa]
| |
| − | #* This path doesn't require a Giraffe.
| |
| − | #* But this will require a 120 Ohm resistor if you want to install a Radar retrofit.
| |
| − | # Giraffe For cars built before May 31, 2013, will need a "TDC Connector".
| |
| − | #*
| |
| − |
| |
| − | Whichever one of these you end up using, install it into the corresponding port under the dash, by the driver's side door.
| |
| − |
| |
| − |
| |
| − | == Installing EON ==
| |
| − | == Installing OpenPilot on the EON ==
| |
| − | === Configuring OpenPilot ===
| |
| − | === First OpenPilot Drive ===
| |
| − | == Hardware Guide ==
| |
| − | == Software Guide ==
| |
| − | == FAQ ==
| |
Latest revision as of 06:04, 16 December 2019
